GenCade 2.0 Grid Coverage

Figure 1. Selecting "Grid Definition Options" for the Grid coverage.

The GenCade Grid coverage allows the user to define the grid to be used by GenCade for all computations in a simulation. This coverage uses Feature Points within the SMS to define the positioning for each type and to assign the attributes:

Notes:

• 

  Figure 2. Adding GenCade simulation to the SMS data tree.
  Only one of this type coverage can be added to the simulation.
• Only one Begin and End point can be created in this coverage.
• As many Refine points can be added as needed to adequately represent all structures and events for the simulation.

This coverage is combined with the GenCade Structures/Events and Points coverages to define all necessary pieces for the GenCade simulation.

Grid Creation

First, the user should use create two points which will define the Begin and Ending points for the GenCade Grid.

See the GenCade_Grid_Point_Attributes dialog for instructions and important notes.

Grid Definition Options

Next, the user should define the default grid cell size for this coverage. This is done by right clicking on the GenCade grid coverage in the SMS Data Tree and selecting "Grid Definitions Options" as shown Figure 1 on the right.

See the GenCade Grid Definition dialog for instructions and important notes.

Add Grid coverage to simulation

Once there is a Begin and End point defined and the default grid spacing has been set, the grid can be built by adding it to a GenCade simulation.

If no GenCade simulation has been added to the SMS data tree, simply right click in the open space within the data tree and select "New Simulation..." and then "GenCade" (Figure 2).

Note: this option is called "GenCade Beta" in SMS 13.3.x.