GenCade 2.0 Grid Coverage

From CIRPwiki
Revision as of 15:24, 28 March 2024 by Rdchlmeb (talk | contribs)
Jump to navigation Jump to search


Figure 1. Selecting "Grid Definition Options" for the Grid coverage.
Figure 1. Selecting "Grid Definition Options" for the Grid coverage.

The GenCade Grid coverage allows the user to define the grid to be used by GenCade for all computations in a simulation. This coverage uses Feature Points within the SMS to define the positioning for each type and to assign the attributes:

Notes:

  • Only one of this type coverage can be added to the simulation.
  • Only one Begin and End point can be created in this coverage.
  • As many Refine points can be added as needed to adequately represent all structures and events for the simulation.

Add GenCade Grid Coverage

This coverage is added to SMS by right-clicking on the "Map Data" icon in the data tree and selecting New Coverage, then Models and then GenCade Beta. Inside the GenCade Beta item, there are three options: GenCade Grid, GenCade Structures-Events, and GenCade Point Attributes. For the Grid coverage, select GenCade Grid.

Note:

  • Until this new interface fully replaces the old interface, there will be the older (GenCade) and newer (GenCade Beta) options in the coverage list.

This coverage is combined with the GenCade Structures/Events and Points coverages to define all necessary pieces for the GenCade simulation.

Figure 2. Adding GenCade simulation to the SMS data tree.
Figure 2. Adding GenCade simulation to the SMS data tree.

Grid Creation

First, the user should use create two points which will define the Begin and Ending points for the GenCade Grid.

See the GenCade_Grid_Point_Attributes dialog for instructions and important notes.

Grid Definition Options

Next, the user should define the default grid cell size for this coverage. This is done by right clicking on the GenCade grid coverage in the SMS Data Tree and selecting "Grid Definitions Options" as shown Figure 1 on the right.

See the GenCade Grid Definition dialog for instructions and important notes.

Add Grid coverage to simulation

Figure 3. Display of resulting GenCade grid.
Figure 3. Display of resulting GenCade grid.

Once there is a Begin and End point defined and the default grid spacing has been set, the grid can be built by adding it to a GenCade simulation.

If no GenCade simulation has been added to the SMS data tree, simply right click in the open space within the data tree and select "New Simulation..." and then "GenCade" (Figure 2).

Note: this option is called "GenCade Beta" in SMS 13.3.x.

Once the grid has been added to the GenCade simulation, it will be generated and appear on the SMS Graphics Window (Figure 3).